Übersicht ... 3D

            ; Script based on an original created by tjjfvi (https://github.com/tjjfvi)
; An up-to-date version of the tjjfvi's original script can be found
; here:  https://csi.t6.fyi/
; Note - This script will not work in Cura V4.2 and above!
; max_feedrate_z_override = {max_feedrate_z_override}
; retraction_amount = {retraction_amount}
; retraction_hop = {retraction_hop}
; retraction_hop_enabled = {retraction_hop_enabled}
; retraction_prime_speed = {retraction_prime_speed}
; retraction_retract_speed = {retraction_retract_speed}
; retraction_speed = {retraction_speed}
; speed_travel = {speed_travel}
; retraction_enable = {retraction_enable}
; layer_height = {layer_height}
; smooth_spiralized_contours = {smooth_spiralized_contours}

; Ender 3 Custom Start G-code
M117 Pre-heating the extruder!
M104 S160; start warming extruder to 160
M117 Getting the bed up to temp!
M140 S{material_bed_temperature_layer_0} ; Set Heat Bed temperature
M190 S{material_bed_temperature_layer_0} ; Wait for Heat Bed temperature
G28 ; Home all axes
M117 Auto bed-level GO!
G29 ; Auto bed-level (BL-Touch)
G92 E0 ; Reset Extruder
M117 Getting the extruder up to temp!
M104 S{material_print_temperature_layer_0} ; Set Extruder temperature
M109 S{material_print_temperature_layer_0} ; Wait for Extruder temperature
G1 Z1.0 F3000 ; move z up little to prevent scratching of surface
G1 X228 Y200 Z0.3 F5000.0 ; move to start-line position
M117 LET THE PURGE BEGIN!
G1 X228 Y20 Z0.3 F1500.0 E15 ; draw 1st line
G1 X227.2 Y20 Z0.3 F5000.0 ; move to side a little
G1 X227.2 Y200 Z0.3 F1500.0 E30 ; draw 2nd line
G92 E0 ; reset extruder
G1 Z1.0 F3000 ; move z up little to prevent scratching of surface
M117 Autobots! Roll Out!
; End of custom start GCode